Bare root standard tree roses are best planted between November and April, during bare root season. This gives them time to establish ready to bloom come summer. The only time we recommend that you don't plant is when the ground is frozen, waterlogged or in drought conditions.


you will need

SPADE          FORK          LARGE BUCKET OF WATER          WATERING CAN          WELL ROTTED MANURE          
DAVID AUSTIN'S MYCORRHIZAL FUNGI          WOODEN STAKE (supplied) (150cm long x 5cm diameter)         TREE TIE (supplied)         
CLOUT NAIL        HAMMER OR MALLET

 


How TO plant a bare root STANDARD tree ROSE

Step 1.

Rehydrate the roots of your standard tree rose in a bucket of water for a minimum of 2 hours prior to planting.

Step 2.

Dig a hole measuring 60cm wide by 40cm deep, removing any weeds or large stones as necessary.

Step 3

Break up the soil at the base of the hole with a fork and mix a spadeful of well rotted farmyard manure (at least 2 years old).

Step 4.

Remove the rose from the bucket of water and whilst holding trunk of the tree in one hand, sprinkle the roots with Mycorrhizal Fungi.

Step 5.

Place the rose upright in the centre of the hole. The stems should be 5cm below the top of the hole - use a bamboo cane to help to identify the level of the top of the hole.

Step 6.

Position the stake around 10cm from the rose stem and drive it down into the ground by 20cm below the bottom of the hole, avoiding the root structure. This should leave the stake 3ft  above ground level. Ideally, the top of the stake should be level with the point at which the trunk of the tree splits into branches. The height of the stake supplied is designed to allow for 3-5 years of growth.

Step 7.

Backfill around the rose using the soil that was originally dug to make the hole - mixing in two more spadefuls of well rotted manure. Then, lightly firm the soil around the rose with your foot.

Step 8.

Using the tree ties, attach the standard tree rose stem to the top of the stake.

Step 9.

Water the rose well.

WATERING: Standard tree roses in pots will require more frequent watering than standard tree roses planted in the ground.



you may also like

How to plant a potted shrub rose

By following these simple steps, you will ensure your potted shrub rose gets off to the best possible start.

How to deadhead roses

There are two stages to deadheading. The first is mainly aesthetic, removing the brown finished blooms so you can enjoy the remaining flowers without interruption.

how to plant a bare root shrub rose

By following these simple steps, you will ensure your bare root shrub rose gets off to the best possible start.

pruning an English shrub rose

The instructions in this article cover the pruning of English Shrub Roses, as well as other repeat flowering shrub roses.